Jamco America partners with Airtech for 3DP tool recycling
Aerospace manufacturer joins forces with composite materials company to achieve sustainable manufacturing practices that overcome traditional composite layup tooling.
Jamco America Inc. (Everett, Wash., U.S.), an interior products supplier and turnkey aircraft interiors integrator in the aerospace industry, announces its partnership with Airtech Advanced Materials Group (Huntington Beach, Calif., U.S.) to advance aerospace manufacturing through 3D printing (3DP) tool recycling. The partnership will reportedly enable faster production of finished goods with reduced risk and cost and a lower total carbon footprint.
The partnership between Jamco and Airtech began in 2006, with Airtech supplying composite manufacturing consumables and supporting materials to Jamco. In 2021, the collaboration expanded into large-format additive manufacturing (LFAM) tooling. Jamco’s goal is to explore LFAM technology for high-temperature applications, aiming to overcome the limitations of traditional composite layup tooling. According to the company, these efforts promise to significantly reduce lead times and supply chain delays while enhancing performance and reducing the risk of defects in finished parts.
The LFAM molds produced by Airtech use its Dahltram I350CF thermoplastic resin, a fully recyclable polymer. Depending on the application’s requirements, Airtech can grind up and compound this resin into a blended or 100% recycled formulation. Ongoing testing at Airtech aims to validate the best blended formulations for high-performance applications such as aerospace tooling and molds.
Through this partnership, Jamco and Airtech aim to revolutionize aerospace manufacturing and enhance product quality, reduce lead times, lower production costs and minimize environmental impact, thus ensuring greater sustainability, cost-effectiveness and safety across the industry.
Related Content
-
The potential for thermoplastic composite nacelles
Collins Aerospace draws on global team, decades of experience to demonstrate large, curved AFP and welded structures for the next generation of aircraft.
-
One-piece, one-shot, 17-meter wing spar for high-rate aircraft manufacture
GKN Aerospace has spent the last five years developing materials strategies and resin transfer molding (RTM) for an aircraft trailing edge wing spar for the Airbus Wing of Tomorrow program.
-
PEEK vs. PEKK vs. PAEK and continuous compression molding
Suppliers of thermoplastics and carbon fiber chime in regarding PEEK vs. PEKK, and now PAEK, as well as in-situ consolidation — the supply chain for thermoplastic tape composites continues to evolve.